Technical Support
Mercedes Valve Block W220 - How to Diagnose and Fix a Bad Valve Block
Mercedes Valve Block W220 - How to Diagnose and Fix a Bad Valve Block
A faulty valve block can cause a number of problems with your vehicle's suspension system, including poor handling and inability to absorb impacts.valve block w220 This is because the Airmatic valve block controls the flow of air to the air springs and regulates the ride height, so when it stops working properly it can have an impact on your car's comfort and handling.valve block w220 Fortunately, this problem is easy to diagnose and fix. The Airmatic valve block is responsible for distributing pressurized air from the air compressor to the suspension struts and pressure reservoir. It is made up of a series of solenoid valves that open and close to control the flow of air and adjust the height of the suspension based on signals from the vehicle's computer. Over time, these valves can get jammed through physical damage or simply wear and tear.
When this happens, the Airmatic valve block can no longer distribute pressurized air throughout the suspension system and the pressure in the reservoir or struts will begin to drop.valve block w220 This will result in the Airmatic suspension warning light coming on and the car sagging. It can also cause the suspension to become uneven or unable to reach its proper ride height, and the car may start to lean one way or another.
Other symptoms of a bad valve block can include difficulty raising or lowering the suspension, and slowness in rising or lowering the vehicle.valve block w220 If you have noticed any of these symptoms in your Mercedes, then you should check the condition of the Airmatic valve block. If the symptoms are caused by a leaking valve, then you should replace the valve block. If the issues are electrical, then you should inspect the wiring connections to ensure that they are secure and not damaged or burned out.
The Airmatic valve block contains six air connections, four for the front and rear suspension struts and one for the pressure reservoir.valve block w220 The valve block is located in the wheel well on the driver's side of the vehicle and can be removed by removing a tire, opening the cover, and releasing the locking pin. It is recommended that you consult a professional to perform this repair, as it requires jacking up the vehicle and working under it, which can be dangerous if you are inexperienced with auto repairs. Once the valve block is replaced, you should check the other parts of the suspension to make sure they are functioning correctly and that no other problems exist. This includes checking the air lines for leaks and rubbing the struts with soapy water to see if there are any bubbles, which indicate that there is air escaping the system. If you do find a leak, then you can use a valve block sealer to stop the leaks.
0users like this.
